 |
 |
 |
|
|
|
[Sponsors] | ||||
INITIALIZATION FROM OBTAINED RESULTS (TEMPERATURE AND VELOCITY FIELD)-BCs DIFFERENT |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 11, 2021, 20:01
|
INITIALIZATION FROM OBTAINED RESULTS (TEMPERATURE AND VELOCITY FIELD)-BCs DIFFERENT
|
#1 |
|
New Member
Rajendra Kumar
Join Date: Feb 2016
Posts: 9
Rep Power: 11  |
Dear all,
I am simulating a porous media, where the flow reverses after a certain interval (say Case A and Case B-SCHEMATIC ATTACHED). I need to change the BCs of outlet and inlet to inlet and outlet respectively, to do so. However, I need to use the obtained solution from Case A to initialize Case B (flow reversal situation). (Not a case of oscillatory flow) I have tried reading from the .cas and .dat files, but of no use. Kindly advise me how to go about it.
__________________
Regards, Rajendra |
|
|
|
|
|
| Tags |
| flow and heat transfer, solution field, solution initialization |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Import .csv - velocity profile - error | eSKa | CFX | 9 | April 3, 2021 14:38 |
| Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 02:27 |
| how to customize the initial velocity and temperature field? | gdtiaozi | FLOW-3D | 1 | December 3, 2013 08:13 |
| Variables Definition in CFX Solver 5.6 | R P | CFX | 2 | October 26, 2004 03:13 |
| transient temperature field with constant velocity | Törnquist | CFX | 0 | September 16, 2003 05:22 |
Linear Mode
