 |
 |
 |
|
|
|
[Sponsors] | ||||
problems about orphan cells when using overset mothed |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 21, 2021, 21:16
|
problems about orphan cells when using overset mothed
|
#1 |
|
New Member
ChengJionghao
Join Date: Dec 2021
Posts: 1
Rep Power: 0  |
There are three components moving in my simulation, I made three overset mesh around them, if I put one component and its overset mesh into background mesh, there is no orphan cell,but if I append another two components into background mesh, there are thousands of orphan cells, three components are not intersecting but three overset mesh are intersecting,how to locate those orphan cells and how to reduce them?
|
|
|
|
|
|
| Tags |
| muti part motion, orphan cell, overset mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
| problem with parallel calculations OF8 mpirun | otaolafr | OpenFOAM Programming & Development | 0 | January 5, 2021 07:33 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |
| killed "snappyHexMesh" | parkh32 | OpenFOAM Pre-Processing | 2 | April 8, 2012 17:12 |
| ghost cells in axisymmetric problems | ma | Main CFD Forum | 2 | May 17, 2004 13:52 |
Linear Mode
