 |
 |
 |
|
|
|
[Sponsors] | ||||
January 5, 2022, 18:30
|
Deforming Mesh Zone - 2.5D Remeshing
|
#1 |
|
New Member
İstanbul
Join Date: Nov 2021
Posts: 4
Rep Power: 6  |
I used a single body.
While dynamic meshing, the rotating part collides with the inlet hole. How should I define it? Remeshing does not occur in wedge(prism) mesh even though I selected 2.5D. When I choose tetrahadral mesh, I can do remeshing. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| [ANSYS Meshing] How to mesh this geometry to get best quality?(provide your suggestion) | Roh | ANSYS Meshing & Geometry | 1 | October 10, 2017 14:23 |
| Separate mesh in one zone by another zone | lazybone | FLUENT | 0 | June 12, 2017 09:56 |
| Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 16:03 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 10:38 |
Linear Mode
