Home > Forums > Software User Forums > ANSYS > FLUENT

How to detect cells where reverse flow is occurring?

Mark Forums Read

Reply

Search this Thread

May 28, 2022, 03:17	How to detect cells where reverse flow is occurring?	#1
bolajsuraj_10 New Member Suraj A Bolaj Join Date: Apr 2022 Posts: 4 Rep Power: 5	Hey, I am performing simulation on multiphase flow but getting message as "reversed flow in 220 faces on pressure-outlet 9". So my question is can i detect the faces where error is occurring? If yes, then how?

Reply

Tags

fluent, fluent multiphase model, reverse flow, rpi wall boiling, two phase flow

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::PrintStack	almir	OpenFOAM Running, Solving & CFD	92	May 21, 2024 08:56
[snappyHexMesh] snappyHexMesh sticking point	natty_king	OpenFOAM Meshing & Mesh Conversion	11	February 20, 2024 10:12
chtMultiRegionFoam speed up	qwertz	OpenFOAM Running, Solving & CFD	8	September 18, 2021 07:16
Problem with divergence	TDK	FLUENT	13	December 14, 2018 07:00
physical boundary error!!	kris	Siemens	2	August 3, 2005 01:32

All times are GMT -4. The time now is 15:32.