Ansys Fluent crashing when starting simulation
Hi,
I've been trying to simulate the flow over a motorbike using Ansys Workbench Fluid Flow (Fluent). I can prepare the geometry with symmetry without any problem and do a proper mesh with tetrahedrons and two bodies of influence and the inflation layers. This results in a mesh with 2939097 nodes and 11427731 elements. Also I have a medium skewness of 0,23322 and a medium orthogonal quality 0,75799. However, once I have all the parameters set up and I start the simulation, before getting the first iteration it crashes. May it be because my computer can't handle that many elements? Or is it something else? Thanks |
in fluent GUI go to tab general in the tree
press Check -> in must give you following at the end of report Code:
Checking mesh.......................... if everything ok here, check your boundary conditions |
Quote:
Quote:
Thanks |
Quote:
Or start the meshing from scratch, produce better mesh by following the criteria guidlines for mesh quality. |
All times are GMT -4. The time now is 23:25. |