CFD Online Discussion Forums - 'This is a post processing only executable' error

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)

- FLUENT (https://www.cfd-online.com/Forums/fluent/)

- - 'This is a post processing only executable' error (https://www.cfd-online.com/Forums/fluent/244234-post-processing-only-executable-error.html)

lettannie

July 28, 2022 11:12

'This is a post processing only executable' error

Everytime i run my calculation this error always pops up, I don't understand where I have gone wrong even though my convergence tolerance has been met

Error: This is a post-processing only executable

Error Object: #f

All times are GMT -4. The time now is 03:02.