Home > Forums > Software User Forums > ANSYS > FLUENT

Werner-Wengle wall function of LES in fluent

Mark Forums Read

Like Tree

1Likes

1 Post By luch1997

Reply

Search this Thread

September 25, 2022, 10:25	Werner-Wengle wall function of LES in fluent	#1
luch1997 New Member Join Date: Mar 2022 Posts: 1 Rep Power: 0	Hi everyone i want to use the text command "define/models/viscous/ near-wall-treatment/werner-wengle-wall-fn?", to enable the Werner-Wengle wall function of LES in fluent，but i am not sure that wall function is enable or not. There are no hints or changes in the software interface. I would be most grateful if anyone could share an experience about how to set a wall function of LES in fluent! maria94 likes this.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
heat transfer with RANS wall function, over a flat plate (validation with fluent)	bruce	OpenFOAM Running, Solving & CFD	6	January 20, 2017 07:22
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 23:56
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 15:11
Error with Wmake	skabilan	OpenFOAM Installation	3	July 28, 2009 01:35

All times are GMT -4. The time now is 03:27.