 |
 |
 |
|
|
|
[Sponsors] | ||||
October 13, 2022, 22:02
|
FLUENT Solution Initialisation
|
#1 |
|
Senior Member
Brett
Join Date: May 2013
Posts: 212
Rep Power: 13  |
Hey all,
I'm getting back into using FLUENT after years of using CFX. I'm wondering how to initialise a simulation using a previous result/data file in the same way you can with CFX. Any thoughts? B |
|
|
|
|
|
October 14, 2022, 05:03
|
|
#2 |
|
Senior Member
|
Assuming it is on a different grid (otherwise, well, it is kind of just the same case), you create an interpolation file from the original case and read it in the new case after the basic initialization
|
|
|
|
|
|
 |
| Tags |
| fluent, initial conditions |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What is the Y+ base heat transfer coefficient in ANSYS fluent solution ? | Kmech | FLUENT | 3 | March 20, 2023 11:20 |
| OpenFOAM vs ANSYS Fluent (Solution and Schemes) | gentodin | OpenFOAM Programming & Development | 2 | February 21, 2021 20:56 |
| solution convergence and mesh density in k-omega model (FLUENT) | ripong | FLUENT | 0 | January 29, 2015 17:09 |
| Problem in using parallel process in fluent 14 | Tleja | FLUENT | 3 | September 13, 2013 10:54 |
| problem in using parallel process in fluent 14 | aydinkabir88 | FLUENT | 1 | July 10, 2013 02:00 |
Linear Mode
