 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2023, 04:03
|
Porous zone in fluent.
|
#1 |
|
New Member
1teph
Join Date: Sep 2023
Posts: 3
Rep Power: 4  |
Hello everyone...I am simulating fluid flow through a porous media in fluent. Is there any way to add an energy source term to the solid fraction of the porous zone? I noticed that the energy source from the UDF is added to the fluid fraction. My case is gas flow through a hot porous solid.
|
|
|
|
|
|
September 14, 2023, 10:29
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,846
Rep Power: 68 |
In the porous region there is on differentiation between fluid or solid. It's porous.
|
|
|
|
|
|
|
September 14, 2023, 23:24
|
|
#3 |
|
New Member
1teph
Join Date: Sep 2023
Posts: 3
Rep Power: 4 |
Thank you for your response
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Problem with Mesh conversion from FLUENT Meshing to OpenFOAM | mn17jyf | OpenFOAM Meshing & Mesh Conversion | 3 | November 1, 2023 10:49 |
| Averaging over iterations for steady-state simulation | CFD student | Fluent UDF and Scheme Programming | 8 | September 22, 2022 04:39 |
| FLUENT porous zone inputs | eishinsnsayshin | FLUENT | 19 | April 17, 2020 05:40 |
| [Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 02:47 |
| [GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 12:25 |
Linear Mode
