Maddy1984 |
March 27, 2024 02:21 |
ParaView (Fluent Data) > How to show contour?
Hello,
I exported my Fluent Data to encas and I read my Data with the "EnSight Reader".
Under "Point Arrays" I see my exported Data and everything is selected:
Point Arrays:
- pressure
- total_pressure
- velocity
- velocity_magnitude
So I press "Apply" to read the Data. It starts reading my data but I get the following errors:
Code:
ERROR: In C:\glr\builds\paraview\paraview-ci\build\superbuild\paraview\src\VTK\IO\EnSight\vtkEnSightGoldBinaryReader.cxx, line 348
vtkEnSightGoldBinaryReader (0000017E3BE48CD0): Invalid part id; check that ByteOrder is set correctly.
ERROR: In C:\glr\builds\paraview\paraview-ci\build\superbuild\paraview\src\VTK\IO\EnSight\vtkEnSightReader.cxx, line 297
vtkEnSightGoldBinaryReader (0000017E3BE48CD0): error reading geometry file
ERROR: In C:\glr\builds\paraview\paraview-ci\build\superbuild\paraview\src\VTK\Common\ExecutionModel\vtkExecutive.cxx, line 753
vtkCompositeDataPipeline (0000017E2F8878F0): Algorithm vtkEnSightGoldBinaryReader(0000017E3BE48CD0) returned failure for request: vtkInformation (0000017E3C115680)
Debug: Off
Modified Time: 519500
Reference Count: 1
Registered Events: (none)
Request: REQUEST_DATA
FORWARD_DIRECTION: 0
ALGORITHM_AFTER_FORWARD: 1
FROM_OUTPUT_PORT: 0
But, my model is loaded, at least I can see it but it only shows "vtkBlockColors". So my question is, how can I see the contour of the pressure/velocity?
Thanks
|