Helppp!! Conjugate Heat Transfer Problem
 

Hi everyone, im a student doing my final year project, which involved investigating how different types of material and wind speed impact conjugate heat transfer. i was tasked to run a experiment which uses a open looped wind tunnel with a heating plate, i would then use ANSYS Fluent and compared the results.

The experimental's heating plate (0.127 x 0.127 m) has a 240 VAC, 450 Watt which has heat flux of around 27900 W/m2 and also includes a safety feature when it reach 150 degree c, the heat flux cuts off.

In the simulation, i have used transient with 600 time steps where i only analysis the results up to when the temperature have reached 150 degree c.
however comparing with the experimental set up, the results are off, one possibility i have notice from the contour plots is no conduction in the solid domain and i dont understand why is it like that. is it because of my settings?
Please help me.
Attachment 99379
Attachment 99378

How are you applying the heat flux? Which solids are you not seeing conduction? I only see one solid in the picture