 |
 |
 |
|
|
|
[Sponsors] | ||||
August 20, 2024, 10:57
|
The issue of interface in FLUENT
|
#1 |
|
New Member
Shirling
Join Date: Aug 2024
Posts: 1
Rep Power: 0  |
I would like to ask how to set the specific item under the interface in Fluent to be a non wall surface, as indicated by the parentheses (wall, id=14)? If it is a wall, the fluid in my pipeline cannot flow out from the interface edge. I am really confused. Please kindly answer. Thank you very much!
|
|
|
|
|
 |
| Tags |
| fluent, fluid, interface |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spurious velocity issue in hybrid version of interFoam and interface tracking method | mykkujinu2201 | OpenFOAM Running, Solving & CFD | 5 | July 19, 2022 17:39 |
| how to run fluent from matlab without using aas toolbox? | artemis96 | ANSYS | 7 | May 23, 2022 13:16 |
| Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 06:15 |
| [ICEM] domain interface in ICEM for fluent | hsn | ANSYS Meshing & Geometry | 24 | November 27, 2012 17:43 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Linear Mode
