 |
 |
 |
|
|
|
[Sponsors] | ||||
How to write a transient profile and read it for transient simulation in Ansys Fluent |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 3, 2024, 13:29
|
How to write a transient profile and read it for transient simulation in Ansys Fluent
|
#1 |
|
Senior Member
Farzad Faraji
Join Date: Nov 2019
Posts: 206
Rep Power: 9  |
Hello everyone
I am simulating the Francis turbine using mesh motion to see pitching effect(with all components as you see in the picture). Now, I want to write data as profile in each time-step for full one revolution and use it as input for just Draft tube(Orange geometry) and make it periodic for other cycles. How can I write it as profile and how can I read it as profile? Thanks, Farzad |
|
|
|
|
|
| Tags |
| ansys fluent, francis turbines, profile, transient |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2way FSi, Initialize with steady solution, Fluent, Transient Sturcural, System Coupli | mmkkeshavarzi | FLUENT | 1 | June 28, 2024 08:03 |
| Transient profile in Fluent | Shamoon Jamshed | FLUENT | 4 | June 4, 2023 22:23 |
| Unsteady Boundary Profile with data file | Arianna | FLUENT | 34 | July 29, 2019 17:35 |
| How to read transient velocity profile data as inlet condition at each time step | hemmt | FLUENT | 12 | July 9, 2018 03:26 |
| Read transient profile file | Explorer | FLUENT | 1 | October 13, 2011 14:21 |
Linear Mode
