 |
 |
 |
|
|
|
[Sponsors] | ||||
February 9, 2025, 14:46
|
Draw a line to get the data
|
#1 |
|
New Member
Join Date: Feb 2025
Posts: 1
Rep Power: 0  |
HI there,
I have a question of set the boundary conditions I am trying to set a Line in the middle of one channel so I can extract the data on temperature, pressure and velocity on it. But I failed to do so because I cannot set the boundary condition right for this line. In my case, I set a periodic condition and mesh motion on these channels to allow them to move up and repeat in this domain. Here is a picture of this: https://1sfu-my.sharepoint.com/:i:/g...e3E4Q?e=FBHlcf Thanks Rj |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] ParaView command in Foam-extend-4.1 | mitu_94 | ParaView | 0 | March 4, 2021 14:46 |
| [OpenFOAM] Take derivative of mean velocity in paraFoam | hiuluom | ParaView | 13 | April 26, 2016 07:44 |
| 8x icoFoam speed up with Cufflink CUDA solver library | kmooney | OpenFOAM Running, Solving & CFD | 42 | November 6, 2012 12:37 |
| OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 05:41 |
| Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 22:45 |
Linear Mode
