 |
 |
 |
|
|
|
[Sponsors] | ||||
February 14, 2025, 11:02
|
Solving a UDS in the boundary layer
|
#1 |
|
Member
Pierce
Join Date: May 2019
Posts: 41
Rep Power: 7  |
Recently I have been aiming to solve a UDS for a velocity.
As such I write the transport equation as rho(q. \nabla)\phi = S_\phi Written with a correct source the velocity field will form. This is generally working however I have artificial values close to the wall that I am trying to eliminate and not sure how to best proceed. Thanks. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| conjugate heat transfer in OpenFOAM | skuznet | OpenFOAM Running, Solving & CFD | 99 | March 16, 2017 05:07 |
| simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
| Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 18:17 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
Linear Mode
