 |
 |
 |
|
|
|
[Sponsors] | ||||
August 19, 2025, 09:42
|
6 DOF axisymmetric simulation parameters
|
#1 |
|
New Member
Akos G.
Join Date: Aug 2025
Posts: 2
Rep Power: 0  |
Hello,
I am running an axisymmetric simulation with 6DOF dynamic mesh. I am defining an external force with an UDF. The results are not what I expect, and I was wondering if I am setting the parameters correctly. According to the Fluent Customization Manual (https://ansyshelp.ansys.com/Views/Se...1-4200003.12.3), in case of a half model, the symmetry plane should be defined in the 6DOF UDF, and the parameters (such as mass) given for the whole model. What's the case for 2Daxi? Do I need to define the axis of symmetry? Divide/multiply my mass or force by pi? Thank you in advance. |
|
|
|
|
 |
| Tags |
| 6dof, axisymmetric, udf |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculation of the Inlet Area in Axisymmetric 2D Simulation | lef47671 | FLUENT | 2 | December 27, 2022 06:52 |
| 2D axisymmetric Supersonic flow simulation | gokenq | FLUENT | 19 | August 5, 2022 14:41 |
| Calculating surface area in Axisymmetric simulation | cwl | STAR-CCM+ | 2 | February 16, 2022 09:51 |
| 2D Axisymmetric simulation with morphing boundary | JM27 | STAR-CCM+ | 9 | September 11, 2018 07:50 |
| LES simulation parameters | manju819 | OpenFOAM Running, Solving & CFD | 5 | November 6, 2016 09:07 |
Linear Mode
