 |
 |
 |
|
|
|
[Sponsors] | ||||
November 7, 2025, 05:02
|
Fluent
|
#1 |
|
New Member
Join Date: Nov 2025
Posts: 2
Rep Power: 0  |
Hi,
I am running a CFD simulation to extract heat flux over a heated plate, I have used mapped meshing and adopted SIMPLE algorithm to solve. During solving mode the continuity part of the residual is increasing. What could the reason for this |
|
|
|
|
|
November 7, 2025, 11:16
|
|
#2 |
|
Senior Member
Kareem
Join Date: Nov 2022
Location: New York
Posts: 157
Rep Power: 6 |
It's likely either mesh quality or how you set up your boundary conditions. What do your inlet and outlet boundaries look like?
__________________
Please like the answer if it helped! Video Tutorials and Tips: https://www.youtube.com/@cfdkareem/featured |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discrepancy between Oka erosion formula presented by source and Fluent | Tonika | FLUENT | 0 | November 4, 2023 20:48 |
| [Commercial meshers] Unknown error when converting fluent mesh to openfoam | Yutao | OpenFOAM Meshing & Mesh Conversion | 0 | April 23, 2023 03:30 |
| CFX vs. FLUENT | turbo | CFX | 4 | April 13, 2021 09:08 |
| heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 07:22 |
| Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 17:48 |
Linear Mode
