Can't start parallel on NT
Has anybody used the parallel version of Fluent on an NT machine? I get error messages when I start it.
I can run the serial version fine but when I try to start the parallel version of Fluent from a DOS window with the command: fluent 2d -t2 I get a message: Cannot read directory: c:\fluent.inc\fluent5.3\ntx86\2d_host Any hints much appreciated, John Faragher |
Re: Can't start parallel on NT
I has used the following command and can start successfully it on NT: c:\fluent.inc\ntbin\ntx86\fluent -t2
|
Re: Can't start parallel on NT
I once had a similar message. The reason was that no parallel version was installed. But it was with Fluent 5.2.
|
Re: Can't start parallel on NT
I am running a fairly complex 3D model using Parallel solver 5.3 on NT. I can start it in any directory. Make sure you have installed the P-version correctly. If you are including DPM in model, becareful, there is a glich in the code. Good Luck.
|
All times are GMT -4. The time now is 14:49. |