Surface Monitors during Transient Analysis

June 1, 2000, 08:53

I am using Fluent to perform transient analysis. During each time-step, I have Fluent monitor certain surfaces for average velocity. For the plots produced (which are updated after each time-step), can the axis (range) be modified?

I have had earlier data which has caused the axis to become very large and thus my good data (small) is hard to see now. Any suggestions would be appreciated.

June 5, 2000, 09:09

Hi, I have the same questions, it is really frustrating. rememer to tell me, if you got the answer

Thanks

June 1, 2000, 08:53	Surface Monitors during Transient Analysis	#1
Alberto Schroth Guest Posts: n/a	I am using Fluent to perform transient analysis. During each time-step, I have Fluent monitor certain surfaces for average velocity. For the plots produced (which are updated after each time-step), can the axis (range) be modified? I have had earlier data which has caused the axis to become very large and thus my good data (small) is hard to see now. Any suggestions would be appreciated.

June 5, 2000, 09:09	Re: Surface Monitors during Transient Analysis	#2
Burley Guest Posts: n/a	Hi, I have the same questions, it is really frustrating. rememer to tell me, if you got the answer Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
Surface monitors in fluent	Ann	FLUENT	4	February 10, 2014 12:36
Restart of transient analysis	usker	STAR-CD	0	April 3, 2009 00:49
Surface monitors with Point	Thanathat	FLUENT	0	March 31, 2008 09:43