Home > Forums > Software User Forums > ANSYS > FLUENT

Validation-Make a circle on 3D

Mark Forums Read

Reply

Search this Thread

October 18, 2000, 04:27	Validation-Make a circle on 3D	#1
Harry Guest Posts: n/a	Hi all, I want to validate my work on impeller outflow, so i need surface like a circle on it. How can i make it, after grid was read in FLUENT, cause as i know, FLUENT only make Sphere in 3D. anyone can help??

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to make the water slightly compressible in CFX?	womo	CFX	14	February 12, 2020 06:20
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 08:48
make a chart in CFX-POST	Alessandro	CFX	1	March 4, 2008 16:24
Urgent: RAE 2822 validation	NID	Main CFD Forum	0	September 3, 2004 10:34
[Q]How to make MPEGs with CFD datas???	Bum-Seok Hyun	Main CFD Forum	4	February 16, 2000 18:59

All times are GMT -4. The time now is 19:53.