|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hello, I have some simulations where the first values for the velocityresiduals begin always very slow in the range of 1e-3 to 1e-4. After they decrease about two decades. What influence has this behaviour on my convergence criterium.
Thank you for your help |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi,
I may be wrong, but I think that low residuals from the outset of a simulation means that your initial guess' are quiet close to the correct solution. As for the level to which they converge, I would say hat you should look at the results, and then lower the residual tolerance by maye 2 more decades and run the problem and see if there is a change in your results. Regards, Jack. |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Tutorials] Tutorial of how to plot residuals ! | anon_r | OpenFOAM Community Contributions | 172 | December 6, 2024 06:20 |
what to monitor besides residuals? | franzdrs | FLUENT | 5 | March 21, 2013 03:59 |
Mesh size and solver residuals... | Scott | CFX | 5 | December 15, 2008 17:10 |
Convergence - scaled vs unscaled residuals | HS | FLUENT | 1 | November 7, 2005 05:45 |
residuals | Karl | CFX | 2 | June 24, 2003 23:13 |