 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2000, 10:20
|
Heat exchanger model
|
#1 |
|
Guest
Posts: n/a
|
I'm trying to set on the heat exchanger module described in § 6.23 . I checked m * cp for air being lesser than m * cp for coolant, set into the model a good amount of hot air, let it pass through the exchange region but nothing happens. The porous behaviour of the region were set on automatically, but no heat exchange ever occured. Do anyone had the same problem? Is there someone with a suggestion? Thanks Massimo
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Exchanger Model | sak2129 | FLUENT | 3 | September 26, 2017 01:29 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Heat Exchanger Model - urgent | JSM | FLUENT | 6 | September 22, 2007 04:25 |
| BIG TROUBLE with heat exchanger and porous media!! | Andrea | FLUENT | 0 | February 20, 2005 07:49 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
