ICEM/GAMBIT FLUENT/CFX-TASCFLOW

February 1, 2001, 11:22

Hi Again,

Another question....does anyone how I can exchange fluent files with files for CFX-TASCflow. Is it possible to export a mesh from CFX-TASCflow and open it in fluent and vice versa?? Also, what is the best format for doing this in if it is possible. Also, I am using Gambit with fluent and ICEM/HEXA with TASCflow. Can the ICEM meshes and geometry be importedinto Gambit and of course vice versa.

thanks

John.

February 4, 2001, 20:01

Hi,

Have a look at http://www.icemcfd.co.uk

on the main page is a list of all supported solvers that you can write meshes out to.

Regards

David

February 1, 2001, 11:22	ICEM/GAMBIT FLUENT/CFX-TASCFLOW	#1
J. Keays Guest Posts: n/a	Hi Again, Another question....does anyone how I can exchange fluent files with files for CFX-TASCflow. Is it possible to export a mesh from CFX-TASCflow and open it in fluent and vice versa?? Also, what is the best format for doing this in if it is possible. Also, I am using Gambit with fluent and ICEM/HEXA with TASCflow. Can the ICEM meshes and geometry be importedinto Gambit and of course vice versa. thanks John.

February 4, 2001, 20:01	Re: ICEM/GAMBIT FLUENT/CFX-TASCFLOW	#2
David Guest Posts: n/a	Hi, Have a look at http://www.icemcfd.co.uk on the main page is a list of all supported solvers that you can write meshes out to. Regards David

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tracer simulation using TASCFLOW	Johnson	CFX	1	September 9, 2003 19:11
Future of Tascflow	TascflowUser	CFX	15	December 4, 2002 09:48
Compilation on Tascflow 2.11	cfd guy	CFX	5	March 15, 2002 13:07
HEXA: 2D grids on Tascflow.	cfd guy	CFX	2	March 1, 2002 14:09
Install problem of X-windows for Tascflow	Alex Deng	CFX	2	November 1, 2001 12:33