 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2001, 04:22
|
Point source in Fluent
|
#1 |
|
Guest
Posts: n/a
|
Dear all,
I am trying to simulate contamiant transport (CO2) in a ventilated room(isotherm). The contaminat is added to the room as a point source by a carrier gas(N2 or He), so we can change its density (heavier or lighter than the room air). My problem is how can I add this source into the Boundary Condition in Fluent? Thank you very much for your help in advance. Cheers, Shengping |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I hope you can point out problems in my FLUENT solution | tp9180188 | FLUENT | 2 | March 15, 2012 11:40 |
| Regarding Fluent Source term | Purushothama | ANSYS | 0 | July 19, 2011 21:53 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
