|
[Sponsors] |
March 21, 2001, 10:32 |
Modelling in Gambit
|
#1 |
Guest
Posts: n/a
|
I have been struggling to create a 3-D pipe with continous spiral surface which for imagination resembles a threaded shaft. Is it really possible to model such an item in Gambit or should I switch on to a more friendly software.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] Gambit Modelling Guide PDF | PLN Prasad | ANSYS Meshing & Geometry | 56 | August 10, 2013 06:40 |
airfoil trailing edge modelling in gambit | morteza08 | Main CFD Forum | 3 | June 4, 2010 13:36 |
Modelling a synthetic jet for a 2-d flat plate using gambit | gaurav | ANSYS Meshing & Geometry | 0 | May 1, 2009 09:59 |
Modelling 3D elbow in Gambit | Karthik | FLUENT | 2 | September 4, 2008 09:39 |
Modelling in gambit | Shanti V | FLUENT | 2 | October 6, 2005 21:55 |