|
[Sponsors] |
how to disable energy equation for for non-newton |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 3, 2001, 03:48 |
how to disable energy equation for for non-newton
|
#1 |
Guest
Posts: n/a
|
Hi: I want to set power law model for Non-Newtonian Viscosity .but I don't want to solve energy equation. I set power law model for Non-Newtonian .and give k,n to describe my Non-Newtonian fluid. When I set boundary condition ,and give fluid matirial. FLUENT will enable energy equation. I try to disable energy equation. But it can't to disable energy equation. someone one can tell me how to set power law model for non-newtonian fluid but not enable energy equation thanks!!
|
|
April 3, 2001, 13:12 |
Re: how to disable energy equation for for non-new
|
#2 |
Guest
Posts: n/a
|
Hi,
I faced the same problem some weeks ago. I did not manage to disable energy equation resolution too. Thus, to prevent Fluent from calculating the temperature field, I defined an UDF for a non-newtonian power law model that does the same as the one defined in Fluent, but without temperature dependance. And it works very well... Anthony |
|
April 3, 2001, 23:11 |
Re: how to disable energy equation for for non-new
|
#3 |
Guest
Posts: n/a
|
Hi: I don't use UDF,can you tell me your cod for non-newtonian power law model . thanks!!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 07:27 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 16:45 |
Viscosity and the Energy Equation | Rich | Main CFD Forum | 0 | December 16, 2009 15:01 |
SIMPLE and energy equation convergence | Fabio | Main CFD Forum | 0 | June 1, 2007 07:06 |
question about energy equation | zhou | FLUENT | 0 | February 24, 2004 00:55 |