|
[Sponsors] |
why I can't show "filled temperature contour" |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 14, 2001, 09:45 |
why I can't show "filled temperature contour"
|
#1 |
Guest
Posts: n/a
|
Hi, Mr. or Mrs:
I am modeling a combustion problem.I want to see temperature distribution with Display->Contour->Temperature. If I didn't select "filled" option, it works well, but it doesn't work once I enable "filled" option. The screen outputs"floating error--out flow".Who can tell me how should I do? Thank you. Sincerely yours, Harry. |
|
June 17, 2001, 08:05 |
Re: why I can't show "filled temperature contour"
|
#2 |
Guest
Posts: n/a
|
Hi Harry,
I already have this kind of problem which seem to arise sometime if you try to plot filled contour on periodic or symetry plane. I solved it by creating a new plane with small ofset from the plane (0.1 mm in my case) Best regards Alain |
|
June 18, 2001, 22:50 |
Re: why I can't show "filled temperature contour"
|
#3 |
Guest
Posts: n/a
|
Hi,Mr. Alain : thank u for ur answer. Sincerely, Harry.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 06:36 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
monitoring point of total temperature | rogbrito | FLUENT | 0 | June 21, 2009 17:31 |
chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 00:07 |