 |
 |
 |
|
|
|
[Sponsors] | ||||
June 19, 2001, 10:27
|
boundary layer mesh
|
#1 |
|
Guest
Posts: n/a
|
Can anyone tell me why Gambit skews my 3D pipe/annulus boundary layer? I use an even number of intervals on my edge mesh, but Gambit always skews the radial parts of my boundary layer instead of them all pointing inward at the cylinder axis! Has anyone else come across this? Help!
|
|
|
||
|
June 19, 2001, 11:45
|
Re: boundary layer mesh
|
#2 |
|
Guest
Posts: n/a
|
split the annulus volume into two volumes using a face. that should help you "map" the source faces and generate a nice mesh.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
| How to make boundary layer mesh moving with wall | wayne | FLUENT | 3 | June 11, 2008 23:23 |
| Is the boundary layer suitable for dynamic mesh? | Lien | FLUENT | 0 | December 26, 2007 01:41 |
| AMG divergence and boundary layer mesh | Justin | FLUENT | 0 | November 4, 2007 17:24 |
Linear Mode
