|
[Sponsors] |
July 7, 2001, 09:25 |
about temperature rising in fluent5.4.8
|
#1 |
Guest
Posts: n/a
|
Hi,
Now I am studying TUT 8.in fluent mannul, "Chemical Mixing and Gas Combustion". I change the air as to oxygen in the boundary of air-inlet,and I don't change the other model. When the solution is converged,I found the temperature rised to 5000k.And this is not true. I've tried everything I can imagine!!! Would you give me some advice? Thanks a lot, in advance...... Devy 2001.7.7 |
|
July 9, 2001, 11:08 |
Re: about temperature rising in fluent5.4.8
|
#2 |
Guest
Posts: n/a
|
Is the temperature lower than expected? Try setting limits to higher temperature. Default maximum is 5000K. If temperature is more than that you give higher value as default maximum. AJ
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 06:36 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
Pressure rising with temperature | Koranten | FLUENT | 0 | August 19, 2009 05:57 |
about temperature rising in fluent5.4.8 | Devy | FLUENT | 2 | April 9, 2001 07:05 |
about temperature rising in fluent5.4.8 | Devy | FLUENT | 2 | April 4, 2001 11:32 |