|
[Sponsors] |
November 19, 2001, 01:38 |
Modelling blast furnace
|
#1 |
Guest
Posts: n/a
|
Hi, Is it possible to predict the shape of the raceway zone in the blast furnace by using fluent?-help me. regards, swasti
|
|
November 20, 2001, 23:43 |
Re: Modelling blast furnace
|
#2 |
Guest
Posts: n/a
|
Well this is probably a non-dilute system so you would need to use the granular model for Fluent 4.5 or wait until Fluent 6 comes out. Even then I think this could be a challenging problem!
Greg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advice on multi-phase flow modelling | Martin | Main CFD Forum | 3 | October 14, 2008 05:16 |
Furnace curtains | Marc | FLUENT | 0 | April 18, 2007 08:01 |
Inclination of the furnace | Clif | CFX | 1 | October 4, 2006 05:48 |
gas-fired furnace modelling | Alexis Devenin V. | Main CFD Forum | 0 | December 3, 2002 11:45 |
Computational Modelling of Vortex Separators | May Lim | Main CFD Forum | 6 | November 13, 1998 12:36 |