|
[Sponsors] |
How to specify window no. in monitor commands pane |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2001, 07:57 |
How to specify window no. in monitor commands pane
|
#1 |
Guest
Posts: n/a
|
Dear all, any one can advice me how to specify the windows number in monitor commands panel for saving hardcopy, case is 3D transient flow, I display two windows for the vof contours in top of view and side of view, and want to save the vof contours,how to specify the windows number in monitor commands panel?
thanks!!! |
|
November 28, 2001, 03:27 |
Re: How to specify window no. in monitor commands
|
#2 |
Guest
Posts: n/a
|
e.g. for window 1:
display set-window 1 or shortened: d sw 1 both should work. Volker |
|
November 28, 2001, 06:19 |
Re: How to specify window no. in monitor commands
|
#3 |
Guest
Posts: n/a
|
thanks, Volker
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Gambit Startup Window | Jay Shim | FLUENT | 2 | February 12, 2015 14:05 |
[GAMBIT] auto close Gambit window | MEDI | ANSYS Meshing & Geometry | 1 | September 3, 2010 06:18 |
[OpenFOAM] New window is hidden behind geometry window | Wenani34 | ParaView | 0 | March 12, 2010 08:50 |
Problem: graphics display in prostar main window | Jiaying Xu | Siemens | 8 | February 14, 2002 08:08 |