|November 29, 2001, 13:53||
SA-turbulent viscosity ratio-help
I am modelling some experimental results of mine for an airfoil in a wind tunnel using 5.5.14. However, when I am going to use the SA model in Fluent, I cannot find sufficient help to compute roughly the inlet turbulent viscosity ratio or the intensity and hydraulic diameter. Although when I use k-e model there is no problems getting the equations from the help menu.
If somebody could help me either find the suitable equations in the help menu, although I maintain they are not that useful, or tell me them I would be very grateful.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turbulent viscosity ratio||Balaji||FLUENT||5||May 27, 2014 03:47|
|hel (turbulent viscosity ratio limited) for supersonic combustion problem||omar.2002bh||FLUENT||2||September 5, 2012 11:04|
|setting value of turbulent intensity and turbulent viscosity ratio in wind tunnel||nuimlabib||Main CFD Forum||0||August 4, 2009 00:05|
|On limiting to turbulent viscosity ratio!||varghese||FLUENT||2||November 15, 2003 09:56|
|Problem of Turbulent Viscosity Ratio Limited||David Yang||FLUENT||3||June 3, 2002 06:13|