|
[Sponsors] |
December 5, 2001, 20:27 |
DPM
|
#1 |
Guest
Posts: n/a
|
When should you run a couple solution (so that the particle injections effect the flow)? Are there any rules of thumb?
|
|
December 5, 2001, 20:34 |
Re: DPM
|
#2 |
Guest
Posts: n/a
|
Of course there is a rule of thumb. The most important parameter is,
(solid mass flow rate) / (gas mass flow rate). As far as I remember(I've forgotten the reference), when the ratio exceeds 0.2, the interaction between gas and particle should be interacted. You can simply test it by increasing the solid mass flow rate continuously. Sincerely, Jinwook |
|
December 9, 2001, 14:34 |
Re: DPM
|
#3 |
Guest
Posts: n/a
|
You also need to take into account a two way coupling if particles introduce mass, momemtum or heat source.
I sugest you to take a look at this book : Multiphase Flows With Droplets and Particles Clayton Crowe, Martin Sommerfeld and Yutaka Tsuji It will enlight you on DPM flow modelling. Best regards Alain |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM and UDS | mighelone | FLUENT | 0 | June 3, 2011 08:27 |
DPM modeling | Mohsin | FLUENT | 0 | March 31, 2010 23:11 |
DPM - do the particles affect the liquid? | Nikhil Dani | FLUENT | 0 | January 1, 2009 12:58 |
slow after mesh for enhanced wall treat DPM | joshkemp | FLUENT | 0 | May 1, 2007 18:20 |
compatibity LES with DPM | Alex Munoz | FLUENT | 0 | March 26, 2003 22:13 |