how to defined the direction vector

December 25, 2001, 10:15

Hi..... I choice porous media that it simulate fluid flow in the channel . otherwise . How to adjust the argument i **direction-1 vector**,**direction-2 vector** in the channel panel. FOR EXAMPLE Now, i simulate three dimensional model , before the operation , i define direction-1 vector {1,0,0} again direction-2 vector {0,1,0} Is it a wrong or right ?????

thanks in advance

January 4, 2002, 08:41

Pl. read section 6.19.4 of FLUENT User's guide vol 1. You can make use of "Line tool" for 2D & "Plane tool" for 3D flow. Best Luck.

Sharad

December 25, 2001, 10:15	how to defined the direction vector	#1
hsin ping chang Guest Posts: n/a	Hi..... I choice porous media that it simulate fluid flow in the channel . otherwise . How to adjust the argument i direction-1 vector,direction-2 vector in the channel panel. FOR EXAMPLE Now, i simulate three dimensional model , before the operation , i define direction-1 vector {1,0,0} again direction-2 vector {0,1,0} Is it a wrong or right ????? thanks in advance

January 4, 2002, 08:41	Re: how to defined the direction vector	#2
Sharad Dugad Guest Posts: n/a	Pl. read section 6.19.4 of FLUENT User's guide vol 1. You can make use of "Line tool" for 2D & "Plane tool" for 3D flow. Best Luck. Sharad

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
OpenFOAM static build on Cray XT5	asaijo	OpenFOAM Installation	9	April 6, 2011 12:21
plot user defined vector	deltamaple	Siemens	1	March 12, 2010 10:46
VECTOR DIRECTION	Josh	FLUENT	0	July 5, 2007 15:47
Direction vector in porous media panel	Claud	FLUENT	0	March 15, 2007 05:04