|
[Sponsors] |
December 27, 2001, 22:51 |
2 zone from 1 zone
|
#1 |
Guest
Posts: n/a
|
Hi All After creating only one zone in gambit, would it be possible to make it (divide into 2) zones in FLUENT (after reading the mesh file (not in gambit) and then apply multiphase models ? (VOF for example??)
DC |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |