|
[Sponsors] |
February 19, 2002, 12:17 |
How to deduce the residual?
|
#1 |
Guest
Posts: n/a
|
Hello, guys,
After 10000 interation or even 20000 , all my variables are below 1e -3 even 1e-5,but one variable--Y velocity is still a little above 1e-3. This value lasted for 10000 interations Anyone has ideas to decrease it? Thanks Jie |
|
February 22, 2002, 06:27 |
Re: How to deduce the residual?
|
#2 |
Guest
Posts: n/a
|
Then, as my personal point of view, it might be O.K. if other situation is consistent, for example, both of heat balance and material balance are O.K.
If you really want to decrease the residual to slightly lower value, just decrease underrelaxation parameters dramatically, e.g., 0.05, and do couple of iterations(10 iteration is enough, I think). But it is, I think, just a trick. The result is not changed so much. Sincerely, Jinwook |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 07:54 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 12:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |