calculation of the initial values

February 28, 2002, 05:46

When I define the boundary conditions at the velocity inlet, I define the turbulence intensity and the hydraulic diameter. Before starting the iteration, I initialize by the computer. It calculates the initial values of the velocity inlet. How does fluent calculate the initial values? I am particular interested in the calculation of the turbulence kinetic energy from the hydraulic diameter and turbulence intensity.

Thanks

Armin

March 1, 2002, 17:26

check the manuals, there are formulla to calculate these. DC

February 28, 2002, 05:46	calculation of the initial values	#1
Armin Gips Guest Posts: n/a	When I define the boundary conditions at the velocity inlet, I define the turbulence intensity and the hydraulic diameter. Before starting the iteration, I initialize by the computer. It calculates the initial values of the velocity inlet. How does fluent calculate the initial values? I am particular interested in the calculation of the turbulence kinetic energy from the hydraulic diameter and turbulence intensity. Thanks Armin

March 1, 2002, 17:26	Re: calculation of the initial values	#2
david Guest Posts: n/a	check the manuals, there are formulla to calculate these. DC

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MRFSimpleFOAM goes divergenced!	renyun0511	OpenFOAM Running, Solving & CFD	0	November 19, 2009 02:11
Problems with simulating TurbFOAM	barath.ezhilan	OpenFOAM	13	July 16, 2009 05:55
TurbFoam problemlarge Co number	sunnysun	OpenFOAM Running, Solving & CFD	6	March 10, 2009 08:05
Negative value of k causing simulation to stop	velan	OpenFOAM Running, Solving & CFD	1	October 17, 2008 05:36
IcoFoam parallel woes	msrinath80	OpenFOAM Running, Solving & CFD	9	July 22, 2007 02:58