Home > Forums > Software User Forums > ANSYS > FLUENT

Mixture as zone type?

Mark Forums Read

Reply

Search this Thread

March 11, 2002, 20:47	Mixture as zone type?	#1
Shankar Guest Posts: n/a	I am working on a system involving multicomponents.Is it possible to specify a zone type as "Mixture" and then specify the concentration of the various components?Is it possible with Fluent? Thanks to all.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
boundary conditions for simpleFoam calculation	foam_noob	OpenFOAM Running, Solving & CFD	8	July 1, 2015 09:07
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 18:51
[Other] cgnsToFoam problems with "QUAD_4" cells	lentschi	OpenFOAM Meshing & Mesh Conversion	1	March 9, 2011 05:49
Pressure instability with rhoSimpleFoam	daniel_mills	OpenFOAM Running, Solving & CFD	44	February 17, 2011 18:08
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50

All times are GMT -4. The time now is 05:03.