|
[Sponsors] |
April 16, 2002, 03:27 |
channel with wire mesh simulation?
|
#1 |
Guest
Posts: n/a
|
hi cfd friends,
I have rectangular channel in that wire mesh(Mesh contains uniform diameter holes) is placed perpendicualr to the direction of flow. can this condition be simulated in fluent 5.5? Thanks in advance. bye |
|
April 16, 2002, 12:46 |
Re: channel with wire mesh simulation?
|
#2 |
Guest
Posts: n/a
|
You could use a porous medium to simulate the momentum sink that occurs across the mesh, but it won't capture any velocity perturbations that might occur in the flow field perpendicular to the primart flow direction.
|
|
April 16, 2002, 13:03 |
Re: channel with wire mesh simulation?
|
#3 |
Guest
Posts: n/a
|
hi Evan,
Thank you for reply. i am interested in the K.E.Dessipation behind mesh. Hence will it give resonable value of E. waiting of reply. |
|
April 17, 2002, 12:40 |
Re: channel with wire mesh simulation?
|
#4 |
Guest
Posts: n/a
|
The porous medium (or porous jump) models will not give you the right turbulence effects. If you want to have it right, you would have to write some sort of UDF.
|
|
April 17, 2002, 14:01 |
Re: channel with wire mesh simulation?
|
#5 |
Guest
Posts: n/a
|
thanks for useful reply bye
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
mesh generation for in-cylinder fluent simulation | hennas | ANSYS Meshing & Geometry | 2 | May 31, 2011 15:08 |
[mesh manipulation] local mesh refinement at channel geometries | Kr_kim | OpenFOAM Meshing & Mesh Conversion | 6 | February 9, 2010 14:25 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |