Thin wall model _Fidap_membrane

May 22, 2002, 03:42

Hello everybody

I have created and meshed a geometry of a human artery in Gambit and I want to analyze the stresses and displacements of the wall. I want to solve it with the thin wall theory in Fidap 8.6.2. The only boundary conditions I use is the pressure (BCFLUX), which is 16000 Nt/m2 (similar in inlet and outlet). Can you help me how can I proceed? Thank you in advance

George

May 27, 2002, 01:44

I have a question: How do you add the pressure boundary conditions on the inlet and oulet of pipe? Can you give me the command text about the above? Thank you very much!

May 22, 2002, 03:42	Thin wall model _Fidap_membrane	#1
George Guest Posts: n/a	Hello everybody I have created and meshed a geometry of a human artery in Gambit and I want to analyze the stresses and displacements of the wall. I want to solve it with the thin wall theory in Fidap 8.6.2. The only boundary conditions I use is the pressure (BCFLUX), which is 16000 Nt/m2 (similar in inlet and outlet). Can you help me how can I proceed? Thank you in advance George

May 27, 2002, 01:44	Re: Thin wall model _Fidap_membrane	#2
jwt Guest Posts: n/a	I have a question: How do you add the pressure boundary conditions on the inlet and oulet of pipe? Can you give me the command text about the above? Thank you very much!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Use of k-epsilon and k-omega Models	Jade M	Main CFD Forum	40	January 27, 2023 07:18
Quenching simulation - wall boiling model	Michael.J	CFX	10	August 27, 2013 17:02
UDF for wall slipping	HFLUENT	Fluent UDF and Scheme Programming	0	April 27, 2011 12:03
3-D turbulence model with wall function	Henry	Main CFD Forum	7	May 19, 2006 10:40
Standard wall function vs Two layer model	C. ORTEGA	FLUENT	0	July 7, 2003 08:35