Vertex problem

April 25, 2002, 14:03

I have an existing geometry sent to me by someone. This geometry consist of vertex, edges and faces. On zooming the faces I found that the vertex does not lie on the intersection of the edges.How should I remove this defect?I dont know the corodiante points of intersection so can not move the vertex also.

I am stuck.Please help me.

April 26, 2002, 16:37

Sometimes display will cause a small shift of vertices - try meshing the faces and see if the mesh would show it as a "defect".

or you could create a vertex by intersection of the two edges - to see if they are the same.

April 25, 2002, 14:03	Vertex problem	#1
Pravir Kumar Rai Guest Posts: n/a	I have an existing geometry sent to me by someone. This geometry consist of vertex, edges and faces. On zooming the faces I found that the vertex does not lie on the intersection of the edges.How should I remove this defect?I dont know the corodiante points of intersection so can not move the vertex also. I am stuck.Please help me.

April 26, 2002, 16:37	Re: Vertex problem	#2
Kang Guest Posts: n/a	Sometimes display will cause a small shift of vertices - try meshing the faces and see if the mesh would show it as a "defect". or you could create a vertex by intersection of the two edges - to see if they are the same.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	10	February 7, 2024 21:50
conduction problem	venkataramana	OpenFOAM	3	December 1, 2013 07:30
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 19:42
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13