 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2002, 06:36
|
Plain-orifice-atomizer
|
#1 |
|
Guest
Posts: n/a
|
Hi!
Could you please give me some explanation about "Azimuthal Start and Stop angle" for Plain-orifice-atomizer. Suppose there is a case where fluid flows thro' a 3D rectangular duct into which I inject liquid from the middle of botttom surface at a certain distance from the inlet. In this case what should be this Start and Stop angle value. Thanking you in advance, Hiranya |
|
|
||
|
May 24, 2002, 10:02
|
Re: Plain-orifice-atomizer
|
#2 |
|
Guest
Posts: n/a
|
I got the answer.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| doesnt have disk atomizer! | eng_norouzi | CFX | 2 | August 14, 2012 08:47 |
| 2D axisymmetric mass flow rate for the plain orifice atomizer | jwillie2000 | FLUENT | 2 | September 17, 2010 06:43 |
| Flow past orifice | aurel | Main CFD Forum | 0 | January 27, 2009 07:46 |
| azimuthal angle in plane orifice atomizer model | sina | FLUENT | 0 | September 23, 2008 02:23 |
| Orifice Flow | Prateep Chatterjee | FLUENT | 4 | February 23, 2001 15:59 |
Linear Mode
