Plain-orifice-atomizer -- CFD Online Discussion Forums

May 23, 2002, 05:36	Plain-orifice-atomizer	#1
Hiranya Guest Posts: n/a	Hi! Could you please give me some explanation about "Azimuthal Start and Stop angle" for Plain-orifice-atomizer. Suppose there is a case where fluid flows thro' a 3D rectangular duct into which I inject liquid from the middle of botttom surface at a certain distance from the inlet. In this case what should be this Start and Stop angle value. Thanking you in advance, Hiranya

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
doesnt have disk atomizer!	eng_norouzi	CFX	2	August 14, 2012 07:47
2D axisymmetric mass flow rate for the plain orifice atomizer	jwillie2000	FLUENT	2	September 17, 2010 05:43
Flow past orifice	aurel	Main CFD Forum	0	January 27, 2009 06:46
azimuthal angle in plane orifice atomizer model	sina	FLUENT	0	September 23, 2008 01:23
Orifice Flow	Prateep Chatterjee	FLUENT	4	February 23, 2001 14:59

All times are GMT -4. The time now is 15:20.