Home > Forums > Software User Forums > ANSYS > FLUENT

Mayday, Mayday.... Gambit help...

Mark Forums Read

Reply

Search this Thread

May 31, 2002, 17:14	Mayday, Mayday.... Gambit help...	#1
Johnix Guest Posts: n/a	<html> Hello everyone, I have a problem running my newly installed gambit2.0 for WINNT. I got the following messages: Cannot open connect stream. TRANS(SocketINETGetAddr): tnamebysocket() failed TRANS(SocketINETConnect): TRANS(SocketINETGetAddr) () failed TRANS(Open): transport open failed for tcp/LOCALPC:0 Unable to open display Does anyone know how to cope with it? Thanks a lot!!! </html>

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 05:22
Gambit help: Cube inside cube	Jack Martinez	FLUENT	13	August 11, 2010 06:29
Gambit 2.3.16, Xming or Exceed...HELP!	bambam3417	FLUENT	10	May 7, 2010 12:39
Gambit -dev X11 doesn't work	Ervin Amet	FLUENT	0	October 28, 2007 08:33
3-D Mesh Check in Gambit.....	SHR	FLUENT	4	March 25, 2003 03:10

All times are GMT -4. The time now is 19:49.