|
[Sponsors] |
July 13, 2002, 01:13 |
UDF
|
#1 |
Guest
Posts: n/a
|
I followed the steps in the UDF manual, chapter 1. I cut and paste one of the UDF codes in that manual (udfexample.c on page (1-10) PDF UDF manual- to specify a pre-defined function for the inlet velocity).
I still get an error message after compiling the source code as interpreted UDF the error is not clear for me. I'm sure that the .c and the .cas files are at the same directory and I read the case file before the compilation. please tell me what I have to do? thanks for your help in advance |
|
July 15, 2002, 13:06 |
Re: UDF
|
#2 |
Guest
Posts: n/a
|
Moh,
Depends on what you paste the codes on? is it just a text editor? and also is it under the same platform as Fluent? Also what is the error message? |
|
July 16, 2002, 13:06 |
Re: UDF
|
#3 |
Guest
Posts: n/a
|
thank you. Actually I copied and pasted it again then it worked. Thank you for you kind help
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh UDF | Qureshi | FLUENT | 7 | March 23, 2017 07:37 |
UDF parallel error: chip-exec: function not found????? | shankara.2 | Fluent UDF and Scheme Programming | 1 | January 16, 2012 22:14 |
How to add a UDF to a compiled UDF library | kim | FLUENT | 3 | October 26, 2011 21:38 |
UDF...UDF...UDF...UDF | Luc SEMINEL | FLUENT | 0 | November 25, 2002 04:03 |
UDF, UDF, UDF, UDF | Luc SEMINEL | Main CFD Forum | 0 | November 25, 2002 04:01 |