CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Boundary layer (

Glenn August 13, 2002 15:43

Boundary layer
Hi all,

how important is stretch/aspect ratio for meshing?. I would like to mesh around a 2d cylinder (radius 0.5). In Gambit I would to like to put a boundary layer of depth 0.006, and use about 100 circumferential points along the edge. However this gives me an aspect ratio of about 60 for the mesh along the cylinder. Does this mean I have to put more points along the cylider to decrease this aspect ratio or is it not important?? Thanks alot

Ashu August 13, 2002 23:55

Re: Boundary layer
Aspect ratio would be useful in predicting pressure drop along the cylinder in your case. So ratio of < 20 would be more appropriate to get better results.


All times are GMT -4. The time now is 05:38.