 |
 |
 |
|
|
|
[Sponsors] | ||||
September 9, 2002, 13:56
|
symmetry
|
#1 |
|
Guest
Posts: n/a
|
hi, while using symmetry conditions, does the FLUENT calculate the forces of just the geometry you see or the complete model with the other half.
I have this doubt because,when i saw the flux report,fluent shows me the value of the entire model instead of showing the half model which is input. can anybody plz explain this to me?? thanks, Mavinakere. |
|
|
||
|
September 12, 2002, 04:41
|
Re: symmetry
|
#2 |
|
Guest
Posts: n/a
|
only half DC
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
| Properly using symmetry with both CFX and ANSYS workbench for a FSI analysis, help! | Cirion0000 | CFX | 0 | July 6, 2009 14:26 |
| Forces in Symmetry | Matt | CFX | 2 | February 25, 2009 05:41 |
| Symmetry plane error in solver | Santiago Orrego. | CFX | 6 | January 31, 2007 07:09 |
| radiation and symmetry | Mark | FLUENT | 2 | November 4, 2004 13:50 |
Linear Mode
