 |
 |
 |
|
|
|
[Sponsors] | ||||
September 13, 2002, 17:39
|
Initializing using existing data
|
#1 |
|
Guest
Posts: n/a
|
Is there any way in Fluent 6.0 to use the data from one case as the starting point for another case without reading the data file? I am trying to keep my data file size as small as I can.
|
|
|
||
|
September 16, 2002, 12:08
|
Re: Initializing using existing data
|
#2 |
|
Guest
Posts: n/a
|
Yes. Use File --> Interpolate. First write an interpolation file from the existing data, then for the new case read that interpolation file back in.
|
|
|
|
||
|
September 16, 2002, 16:14
|
Re: Initializing using existing data
|
#3 |
|
Guest
Posts: n/a
|
Thank you. It worked just fine.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| CGNS vs Tecplot Data Format | LWhitson2 | Main CFD Forum | 3 | July 1, 2011 13:50 |
| Using existing data with a refined mesh | chamoun | OpenFOAM | 1 | February 24, 2010 07:31 |
| Initializing a case with Fluent data in OF15 | johanna | OpenFOAM Pre-Processing | 2 | February 12, 2009 04:08 |
| How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
Linear Mode
