 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2002, 01:42
|
Deformation meshes
|
#1 |
|
Guest
Posts: n/a
|
Hi everybody,
Currently I am starting to work on deformation meshes, especially simulation to predict the piston movement in an internal combustion engine (IC Engine). But I do not know how I start this simulation. Currently I am using Fluent V5.3. Can this version simulate this piston movement? I hope there are persons who can assist me in solving this problem. Thanx. Satyo |
|
|
||
|
September 19, 2002, 09:13
|
Re: Deformation meshes
|
#2 |
|
Guest
Posts: n/a
|
This version cann't solve deforming meshes problem, Fluent 4 or Fluent 6 can do.
|
|
|
|
||
|
September 20, 2002, 10:04
|
Re: Deformation meshes
|
#3 |
|
Guest
Posts: n/a
|
Hi Satyo,
You can find a tutorial example in latest version of Fluent which deals with IC engine simulation.Hope this helps you. Regards, sri |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 08:06 |
| HELP!! How could I obtain structured-orthogonal-body fitted meshes???? | DajeMoo | ANSYS | 0 | January 28, 2011 13:52 |
| [ICEM] how to create meshes of conformal nodes? | snailstb | ANSYS Meshing & Geometry | 2 | March 12, 2010 04:23 |
| Dynamic Meshes | Cfdtoy | FLUENT | 2 | February 6, 2004 13:14 |
| Large 3D tetrahedral meshes | Aldo Bonfiglioli | Main CFD Forum | 4 | August 27, 1999 04:33 |
Linear Mode
