Home > Forums > Software User Forums > ANSYS > FLUENT

Diverge in 2d dam breaking case

Mark Forums Read

Reply

Search this Thread

November 1, 2002, 04:12	Diverge in 2d dam breaking case	#1
Jason Guest Posts: n/a	Hi all, I tried to use fluent to simulate the typical 2d dam breaking problem. If the viscosity of the liquid phase is set as 1cp, fluent can converge normally. However, if I increase the liquid viscosity to 10000 cp (polymer level), fluent diverge quickly. The analysis settings are PISO+geo+0.8 underrelax in pressure.Any comment or suggestion ?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
profile of liquid interface in dam break case!	vivek070176	OpenFOAM Running, Solving & CFD	3	October 18, 2021 08:49
Error reading new case	montag dp	FLUENT	5	September 15, 2011 07:00
Instable natural convection case	Peter88	OpenFOAM	5	August 18, 2011 02:23
[OpenFOAM] Visualization of breaking of a dam tutorial	lasb	ParaView	2	July 13, 2007 09:15
Dam Breaking Problem	B Godderidge	Siemens	0	May 19, 2005 05:35

All times are GMT -4. The time now is 07:28.